Page 1 of 1

Getting roundWidth or roundHeight with Internals Toolbox

PostPosted: Sat Nov 19, 2016 4:56 am
by HairyHighlandCow
Hi,
Is it possible to access the 'roundWidth' or 'roundHeight' properties of a roundrect draw graphic using the internals toolbox? The 'GetSetObjInfo' sample project is pretty comprehensive, but I can't find any reference to 'roundWidth' in there, or in the internals toolbox header file 'InternalsToolbox_472.h'.
All the best,
Alec

Re: Getting roundWidth or roundHeight with Internals Toolbox

PostPosted: Sat Nov 19, 2016 10:28 am
by codegreen
I don't think there's a way at present.

Are you asking out of curiosity, or do you have a real use/need for this?

-Mark

Re: Getting roundWidth or roundHeight with Internals Toolbox

PostPosted: Sun Nov 20, 2016 5:05 am
by HairyHighlandCow
Hi Mark,
I'm making an external which draws graphics into picturedata. One setting it has reads information about the draw graphic it is targeting. So given the name of a graphic, it can find out what type it is e.g. Oval and adjust drawing automatically for that shape type. For roundrects, I can always add an extra parameter to pass the external the roundwidth and roundheight. It would be useful to have access to these properties in the Internals Toolbox at some point, however.
All the best,
Alec

Re: Getting roundWidth or roundHeight with Internals Toolbox

PostPosted: Sun Nov 20, 2016 11:20 am
by codegreen
Makes sense...

Done.

-Mark

Re: Getting roundWidth or roundHeight with Internals Toolbox

PostPosted: Mon Nov 21, 2016 11:15 am
by HairyHighlandCow
Thanks Mark!